We are offering a whole new type of glow hoop unlike any others on the market. This hoop features a 27 program - 19 LED light array. This means you don't have to choose what color your glow hoop is as you'll have many choices all in one hoop.

Programs include: 7 solid colors, 7 strobing patterns with ability to lock in slow to strobe speeds, 5 two-color exchanging patterns, 3 burst patterns, 1 slow fade, and 5 two-color alternating patterns. Hoop may be partially coiled for travel.

LED Glow hoop is powered by a rechargeable, removable, 3.7 V lithium battery (not replaceable by regular 1.5 V batteries). Included are a 110 volt plug in battery household charger and two batteries.

Glow Hoop 34”
diameter of hoop OD 34” (86.3cm)
diameter of poly tubing 0.9 inch (2.3 mm)
weight 15.9 ounce (460 grams)

Glow Hoop 36”
diameter of hoop OD 36” (91.5 cm)
diameter of poly tubing 0.9 inch (2.3 mm)
weight 16.9 ounce (481 grams)

Glow Hoop 38”
diameter of hoop OD 38” (96.5 cm)
diameter of poly tubing 0.9 inch (2.3 mm)
weight 17.5 ounce (519 grams)

hoops include
2 rechargeable AAA batteries
1 AC wall charger

There are no videos for this product.

There is no safety information for this product.

HOOP INSTRUCTIONS

TO BEGIN CUT THE TIE WRAP AND UNCOIL HOOP, you
may have to straighten it out by pulling and
bending here and there to help it along but it
will eventually take on it’s original round
shape.
PLEASE NOTE ! don’t bend near the ends where
it connects because you might damage the
circuit board also when you coil it back up don’t
tie it near the ends or try to connect the ends
together in order to hold it because this might
also put too much stress onto the circuit
board,you can tie it about an inch away from
either side of the push buttons away from circuit
board area.

NEXT CONNECT HOOP ENDS AND MAKE SURE THE
METAL PUSH BUTTON CLICKS INTO PLACE.
YOU WILL NOTICE A SECOND PUSH BUTTON THIS ONE
ENABLES YOU TO GET TO THE BATTERY FOR
CHANGING AND CHARGING . ONLY EXPOSE THE
CIRCUIT BOARD TO CHANGE BATTERY AND REPLACE
BACK INTO TUBE IMMEDIATELY AFTER .

.!! NOTICE THE FLAT END OF THE BATTERY IS AGAINST
THE SPRING ,THIS IS VERY !! IMPORTANT !! SO
WHEN YOU REPLACE ANOTHER BATTERY INTO
THE GHT UNIT MAKE SURE THE FLAT SIDE OF THE
BATTERY (NEGATIVE) IS AGAINST THE SPRING . IF
YOU PUT IT IN THE OTHER WAY IT WILL HEAT UP
AND RUIN THE BATTERY. CHARGE BATTERY TILL
THE GREEN LIGHT STAYS ON ..ABOUT 1- 3 HOURS .
ITS OK TO LEAVE THE BATTERY IN THE CHARGER.

TO LIGHT UP THE HOOP PRESS THE SILICONE SLEEVE
(A BUTTON IS SITUATED UNDER THE SLEEVE).
PRESS ONE TIME TO CHOOSE ONE OF THE 7 SINGLE
COLORS .
TO GET TO B MODE PRESS 2 TIMES WHILE ON THE
FIRST COLOR RED
TO GET TO C MODE PRESS 2 TIMES WHILE ON THE
SECOND COLOR ORANGE.EACH TIME YOU PRESS 2
TIMES IN EITHER MODE B OR C IT WILL CHANGE
COLOR PATTERNS.TO FREEZE ON ANY BLINKING
SPEED OR COLOR PATTERN PRESS 1 TIME AND TO
RESUME SPEED PRESS AGAIN 1 TIME.To shut off press 3
times quickly YOU CAN FOLLOW THE COLOR
CHART PROVIDED.